Connector - Omron KM1 User Manual

0BPreparation
● Connector
This connector is used to connect units to each other.
Inter-unit communication can be carried out to expand functions.
Installation procedure
Lift the cover on top of the product and set the connection connector. Close the
cover before use.
Removal procedure
Open the lid at the top of the product, and remove the connection connector by
hooking a flat head screwdriver on the red circle portion shown in the figure.
* Be careful not to make the flat head screwdriver contact the internal board.
* 1 When multiple units are used within the system, be sure to install the connector by
locking it with the horizontal connecting hook.
2-8