Hardware Installation; Din-Rail Mounting - Planet Networking & Communication IVR-100 User Manual

Industrial 5-Port 10/100/1000T VPN Security Gateway
IVR-100

2.2 Hardware Installation

This section describes how to install the Industrial Gateway. There are three methods to install the
Industrial Gateway -- DIN-rail mounting, wall mounting and side wall mounting. Basic knowledge of
networking is assumed.
Please read the following sections and perform the procedures in the order being presented.
(The device shown on this chapter is just a representation of the said device.)

2.2.1 DIN-rail Mounting

Step 1: Lightly slide the DIN-rail into the track.
Step 2: Check whether the DIN-rail is tightly on the track.
- 22 -