Table of Contents
Advertisement
Chapter 2.
2.1 Physical Descriptions
2.1.1 Front View
Hardware Introduction
LED
P1
P2
Fault
LNK / ACT
1000
Ports
USB Port
Reset Button
Gigabit Port 1-3
Gigabit Port 4
Gigabit Port 5
- 17 -
Industrial 5-Port 10/100/1000T VPN Security Gateway
Green
Lights up when the power is on.
Lights to indicate that power input
Red
has failed.
"Steady on" to indicate the port is
connected to other network device
Green
successfully.
"Blink" to indicate there is traffic on
the port.
"Steady on" to indicate that the
port is successfully connecting to
the network at 1000Mbps.
Amber
"Off" to indicate that the port is
successfully connecting to the
network at 10Mbps or 100Mbps.
USB 3.0 port for system configuration backup
and restoration.
Power on the device and press the reset
button for less than 5 seconds to reboot it or
over 5 seconds to restore it to factory default
settings.
It is a LAN port for connecting to a switch.
Default is LAN port. It can be defined as LAN
port or WAN port.
It is a WAN port for connecting to a perimeter
gateway.
IVR-100
Advertisement
Table of Contents
