Hardware Installation - Planet Networking & Communication HAC-1000 User Manual

LED Color
PWR Green
LNK/ACT Green
Interface Description
This button is hidden in the pinhole. This button is used to restore all the
Reset factory default settings. Please hold the reset button for about 10 seconds
to load default.

2.2 Hardware Installation

A. Wall-mount Installation
To install the PoE Ethernet Switch on the wall, simply follow the following steps:
There are 4 holes with 8mm diameter on the wall; the distance between the 2 holes is
Step 1:
133mm and the line through them must be kept horizontal.
Install a conductor pipe inside the board hole and flush the edge of the conductor pipe
Step 2:
with the wall surface.
Screw the bolts into the conductor pipe. The HAC-1000 is between bolts and conductor
Step 3:
pipe, as shown below.
Z-Wave Home Automation Control Gateway
Description
Lights to indicate that the Switch has power.
Lights to indicate the port is successfully established.
Blinks to indicate that the switch is actively sending or
receiving data over that port.
10
- -
HAC-1000