Wan Ipv6 Setting - Planet Networking & Communication IVR-100 User Manual

Object
Gateway
Interface
Comment

4.5.5 WAN IPv6 Setting

This page is used to configure parameter for IPv6 internet network which connects to WAN port of the
Gateway as shown in Figure
the Gateway's WAN. In this setting you may change WAN connection type and other settings.
Object
Connection Type
IPv6 Address
Subnet Prefix Length
Default Gateway
Industrial 5-Port 10/100/1000T VPN Security Gateway
The gateway is the router or host's IP address to which packet was
sent. It must be the same network segment with the WAN or LAN
port.
Select the interface that the IP packet must use to transmit out of the
router when this route is used.
Enter any words for recognition.
4-25. It allows you to enable IPv6 function and set up the parameters of
Figure 4-25: IPv6 WAN setup
Select IPv6 WAN type either by using DHCP or Static.
Enter the WAN IPv6 address.
Enter the subnet prefix length.
Enter the default gateway of the WAN port.
- 54 -
Description
Description
IVR-100