Chapter 4. Web-Based Management; Introduction; Logging In To The Vpn Gateway - Planet Networking & Communication IVR-100 User Manual

Chapter 4.
This chapter provides setup details of the device's Web-based Interface.

4.1 Introduction

The device can be configured with your Web browser. Before configuring, please make sure your PC is
under the same IP segment with the device.

4.2 Logging in to the VPN Gateway

Refer to the steps below to configure the VPN Gateway:
Step 1. Connect the IT administrator's PC and VPN Gateway's LAN port (port 1) to the same hub /
switch, and then launch a browser to link the management interface address which is set to
http://192.168.1.1 by default.
The DHCP server of the VPN Gateway is enabled. Therefore, the LAN PC
will get IP from the VPN Gateway. If user needs to set IP address of LAN
PC manually, please set the IP address within the range between
192.168.1.2 and 192.168.1.254 inclusively, and assigned the subnet mask
of 255.255.255.0.
Step 2. The browser prompts you for the login credentials. (Both are "admin" by default.)
Default IP address: 192.168.1.1
Default user name: admin
Default password: admin
Administrators are strongly suggested to change the default admin and
password to ensure system security.
Web-based Management
- 35 -
Industrial 5-Port 10/100/1000T VPN Security Gateway
IVR-100