Side Wall Mount Plate Mounting - Planet Networking & Communication IVR-100 User Manual

2.2.4 Side Wall Mount Plate Mounting

To install the Industrial Gateway on the wall, please follow the instructions below.
Step 1: Remove the DIN-rail from the Industrial Gateway. Use the screwdriver to loosen the screws to
remove the DIN-rail.
Step 2: Place the wall-mount plate on the side panel and use the screwdriver to screw the wall mount
plate tightly on the Industrial Gateway.
Step 3: Use the hook holes at the corners of the wall mount plate to hang the Industrial Gateway on the
wall.
Step 4: To remove the wall mount plate, reverse the steps above.
Step 5: Proceed with Steps 3, 4 and 5 in Section 2.2.1 DIN-rail Mounting to connect the network
cabling and power on the device.
Industrial 5-Port 10/100/1000T VPN Security Gateway
- 25 -
IVR-100