Table of Contents
Advertisement
Installing the Fastener
6.6 Marking the ambulance Floor, Table or Tray
MarkIng The TransPOrTer CenTerLIne
Installing to a floating table or tray:
1.
Measure across the table or tray and divide the total by
two. This is the distance to the center of the table or tray.
2.
Measure and mark a point at the center of the tray near
the door end of the ambulance. Measure and mark a
second point at the center of the tray near the forward
end of the ambulance.
3.
Use a chalk line to mark a straight line between the two
points from Step 2. This is the transporter Centerline
(Figure 4).
Transporter Control-End
Reference Line (page 14)
Ambulance
Rear Doors
MeasUrIng anD MarkIng
The LOCk bOx MOUnTIng hOLes
1.
Use the transporter overall length (see
Placement, page 13) to determine where the transporter
should sit on the floor, table, or tray. Draw a line
perpendicular to the Centerline to represent the exact
location of the control end (rear) of the transporter
(Figure 4 and Figure 5).
2.
Beginning where the Centerline intersects the control-
end reference line, measure 250 mm (approximately
9.8") toward the front of the ambulance and draw a
line perpendicular to the Centerline. Center the lock
box on the Centerline with its flat, long end on this
new line (Figure 5).
3.
Use a marker, pen, or other tool to mark the four drilling
points for the lock box on the floor, table, or tray.
14
Figure 4 - Ambulance Compartment Layout (Top-Down View)
Transporter
Installing to an ambulance floor:
Follow the procedure at left to center the fastener on the
floor, OR follow the steps below to place the fastener as
close to the side wall as possible:
1.
Starting at the side wall near the doors, measure and
mark a point 300 mm (minimum) from the side wall.
At the forward end of the compartment, measure and
mark a second point at the same distance.
2.
Use a chalk line to mark a straight line between the two
points from Step 1. This is the transporter Centerline
(Figure 4).
Floating Table or Tray
(if present)
C L
(Centerline)
Transporter Outline
(Reference; not needed)
Transporter Control-End Reference Line
250 mm
Ambulance Doors
Figure 5 - Marking the Lock-Box Mounting Points
© Ferno-Washington, Inc 234-3458-00 July 2010
FL1 Fastener
Lock Box
C L
Mark the 4
Drilling Points
Advertisement
Table of Contents
