Table of Contents
Advertisement
CHAPTER 4: BIOS SETUP
You need to setup a system once every time:
· You start a new and unconfigured system.
· You receive a start-up error message indicating the configuration
information stored in the non-volatile CMOS RAM has somehow
become corrupted.
· You add, remove or change peripherals from your system.
The first time you power up the system, the configuration information
stored in the battery-backed CMOS RAM may not be correct. The BIOS
detects this condition and prompts user to go through the SETUP section.
This chapter explains how to use the BIOS SETUP program and make
the appropriate entries.
ENTERING SETUP
1. Reset the system by turning it OFF then ON or pushing the "RESET"
button on the system front panel.
2. Hit the <Del> key momentarily as soon as the following message
appears:
"Hit <DEL>, if you want to run SETUP"
3. After you press the <Del> key, the following BIOS Setup screen
appears:
486MIS System Board User's Manual
Some of the parameters are
already factory preset and do
not
need
to
Please read the instructions
carefully and only change the
settings if necessary.
be
changed.
Page 27
Advertisement
Table of Contents
