Using The Bios Setup Program; Setting The Bios Configuration Jumper Block - Intel D875PBZ Quick Reference

See Figure 9 for the location of the power connectors.
1. Observe the precautions in "Before You Begin" on page 3.
2. Connect the 12 V processor core voltage power supply cable to the
2x2 connector.
3. Connect the main power cable to the 2x10 connector.

Using the BIOS Setup Program

The BIOS Setup program can be used to view and change the BIOS settings for
the computer. The BIOS Setup program is accessed by pressing the <F2> key
after the Power-On Self-Test (POST) memory test begins and before the
operating system boot begins.

Setting the BIOS Configuration Jumper Block

CAUTION
Always turn off the power and unplug the power cord from the computer
before changing the jumper block settings. Moving the jumper with the
power on may result in unreliable computer operation.
The BIOS configuration jumper block (see Figure 10) determines the operating
mode of the BIOS Setup Program and enables BIOS recovery in the event of a
failed BIOS update.
1
3
J7J2
Figure 10. Location of the BIOS Configuration Jumper Block
Intel Desktop Board D875PBZ Quick Reference
OM15672
19