Clear Password Jumper; Display Type Jumper - Intel 486MIS Quick Start Manual

Clear Password Jumper

Jumper JP32 is used to clear the system password if user were to forget
it.
Normal Password Operation
BIOS performs infinite loop test and clears
system password
Follow these steps to clear system password:
1. Turn power OFF.
2. Open the system cover and gain access to jumper JP32 and W1.
3. Short jumper JP32 and disable SCSI BIOS through jumper block W1
as shown below:
¢
¢
I1
4. Turn power ON.
5. Wait for the system to finish one self-test loop, then turn power OFF
again.
6. Open jumper JP32 and re-enable SCSI BIOS through W1.
7. Replace and secure the system cover.
8. Turn power ON, password data should be cleared.

Display Type Jumper

Display Type
Video display
Monochrome.
Video display is CGA.
FLASH BIOS Jumper
Page 10
Function
¢ ¢
¢ ¢
I2 B1
is VGA,
486MIS System Board User's Manual
JP32
OPEN
(Default)
SHORT
¢ ¢
¢ ¢
B2 E
JP16
EGA, or OPEN
(Default)
SHORT