Barco MatrixPRO User Manual page 75

j~íêáñmol=oÉãçíÉ=`çãã~åÇë
The table below lists MatrixPRO remote commands. Click the hyperlink for detailed
descriptions and examples.
Table B-4. MatrixPRO Remote Commands
Command
HELP
CLEAR
CSUMSTAT
FPLOCK en
GADD grp out in
GCLEAR grp
GDEL grp out in
IPCONFIG I3 I2 I1 I0
ISTAT num
LOADRMP
OBLNK out blnk
OSTAT
PRST num
PSTAT
RCLKEN num en
RESETMP op
RNOV
RPRST num
RTEMP out in
SBAUD mode
SMODE mode [485id]
SWITCH mode
TAKE en
UNOV
MatrixPRO • 16x16 and 8x8 HD/SD-SDI Router • User's Guide
Capabilities. Send complete list of commands available in ASCII format
Clear all matrix video routings
Display Main Code/RBF Checksum info
Locks/unlocks Front Panel control
Add an output or input to group
Clears grouping information
Remove output, input from group
IP address configuration I3.I2.I1.I0
Input video status
Places unit into loader mode for firmware upgrade
Displays output channel status
Displays output status in ASCII
Saves current front panel configuration to a Preset location
Displays preset status in ASCII
Enables/Disables individual output reclockers
Reset MatrixPRO, recall saved Flash values op [R|F] Reset|Factory Reset
Recall Flash settings
Recall preset from a Preset location
Route inputs to outputs. If output is in group, group is routed too
Sets Baud Rate. 0=19200, 1=28800, 2=38400, 3=57600
Serial Mode. 0=RS232, 1=RS485. [485id] opt if RS232
Switching Mode. 0 = (Vertical Interval Switching Off), 1 = On
en = 1 simulates a TAKE button pushed on the front panel (i.e takes all preliminary
routes and makes them permanent). en = 0 simulates a CANCEL button pushed
Save current settings to FLASH
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
MatrixPRO Remote Commands
Description
65