Barco Rev03 Information Manual

Encore presentation system router support (code revision 2.33.00 or higher)

Download this manual

Encore Presentation System Router Support

Rev 03

Encore Presentation System Router support

(Code Revision 2.33.00 or higher)

 AutoPatch

 Barco MatrixPRO-II Analog, 3G SDI and DVI

 Barco MatrixPRO Analog, SDI and DVI

 Barco FSN Presentation Switcher

 BlackMagic Videohub SDI

 DVILink 18x18 DVI

 Extron

 FSR Pathfinder

 GefenPRO DVI

 Grass Valley

 ISIS

 Lantronix UDS-200/UDS-2100 Serial-to-Ethernet device

 Leitch

 LightWare

 Nevion SDI

 Nvision SDI

 Opticis DVI

 Purelink DS-1818M II DVI

 Sierra

 PureLink-2 (PM Series – 32x32 HDMI, DVI, 3G-SDI, firmware 2.20)

- 1 -

Page 1 Rev 03 Encore Presentation System Router support (Code Revision 2.33.00 or higher)  AutoPatch  Barco MatrixPRO-II Analog, 3G SDI and DVI  Barco MatrixPRO Analog, SDI and DVI  Barco FSN Presentation Switcher  BlackMagic Videohub SDI  DVILink 18x18 DVI ...
Page 2 COMM port. Ethernet connection is only supported via the Lantronix device. o Only level 0; only one connection type (Analog, DVI or SDI). Mixed configurations are not supported  Barco MatrixPRO-II Analog and 3G SDI and DVI routers (Ethernet Only) o IP port number: 23 - 2 -...
Page 3 Encore Presentation System Router Support Rev 03  Barco MatrixPRO Analog, SDI and DVI routers o Pressing the "SAVE" button on the Controller will cause the current state of the router to be saved as Preset 1 in the router.
Page 4 Encore Presentation System Router Support Rev 03 device is connected to the Encore network, before applying Power to the Lantronix device. This will ensure that the Lantronix device will get a 192.168.0.xxx address from the Controller since the Controller is a DHCP server.
Page 5 Encore Presentation System Router Support Rev 03  PureLink PM Series o Select the PureLink-2 protocol for the Manufacturer in the router setup menu. o Supports both Ethernet and RS-232 communications. o Router’s factory reset default IP is 192.168.0.2, which conflicts with SP2 Controller.

Matrixpro-ii Matrixpro