Barco MatrixPRO User Manual page 31

3. Operation
sca=_êáÖÜíåÉëë=jÉåì
From the System Menu, select VFD Brightness to adjust the vacuum fluorescent display
(VFD) brightness.
To change brightness:
1.
2.
pÉêá~ä=jçÇÉ=jÉåì
From the System Menu, select Serial Mode to display the Serial Mode Menu.
Figure 3-7. MatrixPRO Serial Mode Menu
This sub-menu enables you to determine the mode of serial communication. The choices
are RS-232 or RS-485. RS-232 signalling is used when there is a direct connection
between a control function and the switcher. RS-485 signalling is used when there are
many devices attached to a party-line communications ring. Each Node on the party-line is
assigned a number for addressing purposes.
To determine the mode of serial communication:
1.
2.
3.
opJOPO=pÉííáåÖë=jÉåì
From the System Menu, select
Figure 3-8. MatrixPRO RS-232 Settings Menu
This menu allows control of serial communications parameters for both RS-232 and RS-
485. The parameters listed above show the default settings that result from a Factory
Reset, or by issuing a Reset from this menu.
MatrixPRO • 16x16 and 8x8 HD/SD-SDI Router • User's Guide
SEL
Press , then rotate the selector knob until the desired brightness is achieved.
SEL
Press to accept the new value, then
SERIAL MODE
> RS-232
SEL
Press to enter the edit mode, indicated by the edit cursor (#).
Rotate the selector knob to access the two modes.
Press SEL to make the desired choice, then press ESC to exit.
RS-232 Settings
RS-232 SETTINGS
> Baud Rate
Parameters
Handshaking
Reset
Menu Structure
ESC
to return to menu navigation.
to display the RS-232 Settings Menu.
57600
N81
ON
21