Troubleshooting - Intec TURBO FORCE HP2 Instruction Manual

TroubleShooting

Problem
Blower #1, Blower #2, Agitator
or Airlock LED's do not light up.
Blower #1 does not run.
Power On light ring does not
illuminate.
Agitator does not run.
T: 303-833-6644
Original Language - English
Likely Cause
Power cord connection is loose.
Power cord not connected at
machine or power source.
Circuit breaker(s) has tripped.
Circuit breaker at power source
as tripped.
LED may have burnt out
Electrical system may have a
loose wire.
Blower #1 circuit breaker may
be tripped.
Rotary Switch in wrong position
for operation
Blower could be burnt out
Light could be burnt out
Switch could be bad
Blower has to be on for Agitator
to come on.
Blower has not been on for 3-4
seconds.
Agitator circuit breaker may be
tripped.
Switch could be faulty
800-666-1611
or
Instruction Manual
Remedy
Ensure appropriate power cord
connection at machine.
Ensure appropriate power cord
connection at power source.
Connect power cord.
Push to reset circuit breaker(s).
Reset circuit breaker.
Attempt to run system
Call Tech Support
Reset Blower #1 circuit breaker.
Set Rotary Switch to correct
position.
Call Tech Support
Attempt to run system
Call Tech Support
Turn blower on.
Agitator time delay requires
blower to be on for 3-4 seconds
for agitator to activate.
Reset Agitator circuit breaker.
Call Tech Support
www.inteccorp.com
| 15