System Operation - Intec TURBO FORCE HP2 Instruction Manual

System Operation:

1. Energize System
a. Plug in Power Cords. If you do not plan to run Blower #2 you can run system off of 2
power cords. In order to run both Blower(s) all 3 power cords will need to be utilized.
b. 4 Blue LED lights in lower right hand corner for Blower #1, Blower #2, Agitator and
Airlock should illuminate. If they do not, ensure that circuit breaker is not tripped. Reset
if needed by pushing the circuit breaker back in.
c. Pull out the Emergency Stop Button
d. Press the Power On button- Power On button ring and Variable Speed button ring will
illiminate.
T: 303-833-6644
Original Language - English
Emergency Stop Button (Pull out to run, push in to stop)
Variable Speed Dial- Controls the speed of
Blower #1 when the Variable Speed
Button is in the "ON" setting
Remote Receptacle
Blower #1, Blower #2, Agitator and Airlock
LED Lights
And Circuit Breakers
Blower #2 Control Switch
800-666-1611
or
L.R.T Antenna: shown in the transport
position (folded down). This Antenna is
hinged and during operations should point
straight out.
www.inteccorp.com
Instruction Manual
| 6