Intec TURBO FORCE HP2 Instruction Manual page 17

Problem
Machine is on, yet no material
comes out of hose.
Variable Speed is 'on' and
Variable Speed Setting is below
100%, yet still a lot of air flow.
T: 303-833-6644
Original Language - English
Likely Cause
Foreign material causing jam in
hopper.
Slide gate is closed.
Insulation blockage in hose.
Blower is off.
Air pocket in hopper is
preventing insulation from
feeding into agitators.
Airlock seal is worn.
Airlock has an obstruction
preventing insulation from
exiting.
Blower #2 is on.
Variable Speed Setting needs to
be decreased.
800-666-1611
or
Instruction Manual
Remedy
Remove power cords, clear jam,
and restart system.
Open slide gate.
Turn system off, remove hose
and clear blockage.
Turn blower on.
Disconnect electrical power.
Redistribute insulation material
inside hopper.
Inspect airlock seals for cuts
and wear. Call Tech Support if
necessary.
Disconnect electrical power,
remove obstruction.
Turn Blower #2 off
Reduce Variable Speed Setting
closer towards zero.
www.inteccorp.com
| 16