Troubleshooting - Intec FORCE/3 HP2 Instruction Manual

TroubleShooting

Problem
Machine does not turn on.
Blower does not run.
Problem
Agitator does not run.
T: 303-833-6644
Original Language - English
Likely Cause
Power cord connection is loose.
POWER ON BUTTON not in on
position.
ROTARY CONTROL SWITCH not
in desired position.
Power cord not connected at
machine or power source.
Machine's circuit breaker has
tripped.
Circuit breaker at power source
has tripped.
Electrical system may have a
loose wire.
Wired remote cord & electrical
panel switches need to be in
'ON' position for machine to
turn on.
Blower's circuit breaker needs
to be reset.
Faulty Blower motor
Likely Cause
Blower has to be on for agitator
to come on.
Agitator circuit breaker needs
to be reset.
Foreign material causing jam in
hopper.
800-666-1611
or
Instruction Manual
Remedy
Ensure appropriate power cord
connection at machine.
Ensure appropriate power cord
connection at power source.
Press POWER ON BUTTON in for
it to light up green.
Rotate ROTARY CONTROL
SWITCH to the location you
desire for system control. Then
utilize appropriate remote is
selected wired or wireless.
Connect power cord.
Reset circuit breaker(s).
Reset circuit breaker.
Contact Intec Tech Support
Place the electrical panel
blower and agitator switches in
the 'ON' position. Place the
remote's blower switch in the
'ON' position; place the
remote's agitator switch in the
'ON' position.
Reset blower circuit breaker.
Contact Intec Tech Support
Remedy
Turn blower on.
Ensure agitator circuit breaker
is reset.
Remove power cords, clear jam,
and restart system.
www.inteccorp.com
| 14