Intec TURBO FORCE HP2 Instruction Manual page 18

Problem
Insulation exiting hose is
dribbling out.
Circuit breakers need resetting
often.
Machine makes a banging noise
when agitator is operating.
Material Feed not consistent.
Product in hopper, yet product
not coming out of hose and
agitator is on.
T: 303-833-6644
Original Language - English
Likely Cause
Heavy insulation material.
Kink in hose.
Airlock seal is worn.
Low voltage or low amperage.
Extension cord gauge is too
small.
Chain is not aligned with
sprockets.
Chain is loose.
Chain is not aligned with
sprockets.
Product is bridging in hopper.
800-666-1611
or
Instruction Manual
Remedy
Push slide gate in 1-2 holes.
Turn up variable speed on
Primary Blower.
Turn variable speed selection to
'off' to allow for maximum
power on Primary Blower.
Turn on Auxiliary Blower.
Straighten hose.
Inspect airlock seals for cuts
and wear. Call Tech Support.
System requires 115V / 15amp
separate circuit for agitator and
each blower.
Use a 12/3 heavy duty (i.e.
SJ300V) extension cord with
115V.
Disconnect electrical power.
Call Tech Support for guidance
if necessary to realign
sprockets.
Disconnect electrical power.
Tighten chain. Call Tech Support
for guidance if necessary.
Adjust chain tensioner.
Disconnect electrical power.
Call Tech Support for guidance
if necessary to realign
sprockets.
Load insulation as shown in
System Operation Step 6.
www.inteccorp.com
| 17