How The System Works - Intec TURBO FORCE HP2 Instruction Manual

Instruction Manual
| 4

How the System Works

OVERVIEW: Cellulose, Fiberglass, or Stone Wool insulation is loaded into the hopper. The insulation
goes thru or under the Breaker Bar. The agitator breaks-up and conditions the insulation for proper
density while also sweeping the insulation into the airlock. The airlock transports the insulation into
the airstream created by the blower system. Insulation is discharged from the airlock, through the
machine outlet, and into the hose. The insulation is further conditioned as it travels through the hose.
An introduction to key components of the system
follows:
Load Platform
Hopper
Electrical Panel
Agitators
Filters
Electrical Panel: The electrical panel, combined with
the wireless and/or wired remote, provides operation
of the machine.
Loading Platform: The loading platform acts as a shelf to support the bag of insulation being
loaded into the hopper.
Hopper: The hopper contains the insulation being
Filters: Ensure clean air is being used for blower intake and cooling.
Agitators: The agitators condition the fibrous insulation. The configuration of the agitators
enable high production rates and appropriate insulation conditioning. The agitators also transport the
insulation into the airlock.
Slide Gate: The slide gate is between the agitators and the airlock. The slide gate allows insulation to
fall into the airlock. The slide gate is opened fully during typical operation. Close the gate slightly to
increase the conditioning of the insulation and alter ratio of insulation to airflow.
Airlock: The airlock transfers the insulation from the agitation system into the airstream without
coming into contact with the blower. Insulation is discharged from the airlock into the hose.
T: 303-833-6644 800-666-1611 www.inteccorp.com
or
Original Language - English