Bulbs And Light Unit Replacement; Headlamp Beam Alignment; Front Flasher/Sidelamp - Lotus Esprit Series Workshop Manual

C
Raising and lowering the headlamp pods when the lights are switched on and
off respective1 y.
To flosh the headli
2.
ogainst the bias spring.
3. To heat the rear screen when selected.
O n Federal vehicles only a relay connects
swttch to the supply.
AND
BULBS
Headlamps
2.
Remove the cross-headed screws securing the front rim to the seating rim,
and withdraw the front rim.
3. Lift the light unit from.its location ond detach the adaptor (cable connector
for remowl i s almost identical to that given above (sealed beam unit),
except that after detaching the slotted adaptor, the bulb i s removed by dis-
engagtng the two ends of Its spring retaining clip f r q the tabs on the bulb
4. Replacement of the light unit (or bulb) i s a reversal of the removal procedure,
but ensure that the adaptor
the unit.
5.
6.
Replace the front bezel.
Beam Alignment
Each headlamp I s provlded with two trimming screws, one for adjustment i n the vertical
(A
plane of Fig. l), and the other for adjustment in the lateral plane
a reference plane for beam atming, using either spirit-level, or optical type beam
Front Flasher/Sldelamp
hts momentarily when the stolk switch
g
LIGHT REPLACEMENT
ELECTRICAL EQUlPMERlT
ARO valve and oil pressure
a
fully entered on the proiections on the bock of
i s
the front which retains the ilens.
Page
M3
pulled back
i s
4
screws.
(B
of Fig.1).
ESPRIT
04/78