Rear Hubs - Lotus Esprit Series Workshop Manual

Page
G4
Refit the brake caliper and tighten the mounting bolts to their specified
4.
torque loading.
Refit the road wtieel and tighten nuts to their specified torque loading.
5.
NOTE:

REAR HUBS

To Remove
Remove the road wheel, split pin and hub retaining nut.
1.
2. Tap loose, and remove the cone spacer.
Using a suitable puller, remove the hub from the spline on the driveshaft.
3.
To Repluce
Slide hub on to the driveshaft spline.
1.
shaft and the cone iriner bore of the hub, the surface of the castellated nut
and spacer are
ESPRIT
A l l
Specifications and Torque L.oadings w i l l be found i n
TECHNICAL DATA.
ALL
PERFECTLY CLEAN A N D
Front hub
Check that the ground surface of the
FREE
GRIT, ETC.,
FROM