Vanraam Easy Go User Manual page 24

Table of Contents

Advertisement

Battery Deep Sleep Mode
When the battery is nearly empty and has not been used for a week, the battery will enter
deep sleep mode. In this mode the battery uses as little power as possible, to increase the
lifespan of the battery.
When the battery is in deep sleep mode, it cannot be used. By pressing the button on the
battery, the battery will be woken up from deep sleep mode, and it can be used again. It is
recommended to first charge the battery before using it in that scenario.
Charging and maintenance tips for the battery
Never leave the bike with an empty battery! We advise you charge the battery as
soon as possible before it's totally empty.
The best storage-charge of the battery is when three to five LED lights are lit.
Check the battery every month in the winter. If fewer than three LED lights burn,
recharge the battery.
Preferably store and use the battery in environments of 5 to 20 ºC. Avoid higher or
lower temperatures.
Do not charge the battery in sunlight and make sure that the battery is not charged
at a temperature of less than 5 ºC.
Only use the charger indoors and in non-humid environments, the charger should
not get wet.
Only use the Van Raam supplied battery.
Only charge the battery with the supplied charger!
The battery housing and charger housing may never be opened! When there is a
problem, contact your dealer.
The Van Raam battery may not be revised due to serious safety risks and the
incorrect functioning of the electric system as a whole.
Don't drop the battery, this can cause external and internal damage.
If your bicycle has a fault, the battery should be disconnected from the bicycle.
Keep in mind that your bike provides less support when it's cold (0ºC and less) and the
battery will discharge faster. Charging also takes more time at lower temperatures.
Version 21.01
24/43

Advertisement

Table of Contents
loading

Table of Contents