Related Manuals for Vanraam Twinny
Summary of Contents for Vanraam Twinny
- Page 1 User manual Twinny Twinny Plus Kivo Kivo tricycle Van Raam BV Aaltenseweg 56 7051 CM Varsseveld Version 14.10 The Netherlands...
-
Page 2: Table Of Contents
Aaltenseweg 56 7051 CM Varsseveld The Netherlands Tel. : +31 (0)315 257370 E-mail : info@vanraam.com Internet : www.vanraam.com Conformity Van Raam declares as manufacturer that the Tandem bicycles have been produced in accordance with the 93/42/EEC guidelines. User manual Tandems 14.10... -
Page 3: Introduction
Introduction This user manual gives important and necessary information about the use of your tandem bicycle. We ask you to go through the manual thoroughly before using the bicycle. READ THOROUGHLY Delivery bicycle with possible packaging user manual(s) possible charger(s), depending on options sparekey(s) Intended usage The tandem bicycle is designed for normal use on a level and solid surface. -
Page 4: Safety Measures
There is a reversing feature present on the Twinny Plus and Kivo tricycle. Practice the reverse function! Please be careful not to switch on the reverse function of the electric motor inadvertently. -
Page 5: Delivery Inspection
Load The maximum load should not be exceeded. See information in the index of technical details on page 26. By permitted load we mean the total load, including the load on the luggage rack. Make sure that the permitted load on the luggage rack is not exceeded. Damaged or worn out parts The replacement and repair of parts (frame, forks, illumination, brakes, drive mechanism and the handle bars) should always be performed by a dealer. - Page 6 Saddle height When the cyclist is sitting on the bicycle and can put a foot on the pedal in the lowest position, the saddle height is correct. Adjust the saddle height in such a way that the leg is stretched but relaxed in that position.
- Page 7 Handle bar height The height of the handle bars affects the comfort of the ride. It determines the pressure on the hands and the position of the back. Determine your own most comfortable height by using the bike. To adjust the handle bar: Loosen the screw with an Allen wrench a few turns.
-
Page 8: Accessoires
Accessoires Depending on your order, you can use the accessories as described below. Crank shortener The crank shortener is fitted to the crank, as illustrated. The pedal can then be fitted into the crank shortener at two positions. With the socketed screw (A) the crank shortener should be aligned with the crank. - Page 9 Lower leg support To fit the lower leg support: First fit the lower leg support to the metal plate (A). The lower leg support is then fitted to the foot support. Make sure that plate (B) is under the pedal and plate (A) is between the pedal and the foot support.
- Page 10 Optional dividable frame (not a standard option with the Kivo) The bicycle can be divided into 2 parts. To divide the frame: Put the bicycle on the standard and remove the grip from the handle bars. Push the pellets of the small spring (A) so that the grip can be removed from the handle bars.
- Page 11 Walking-stick holder The walking-stick holder is fitted under the luggage rack. The walking-stick should be fastened with Velcro (A). Walking-stick holder Twinny and Kivo: Walking-stick holder Twinny Plus and Kivo tricycle: User manual Tandems 14.10...
- Page 12 Back support Set the correct depth, by loosening the four bolts [A] with an Allen wrench, moving the handrail to the correct position and then tighten the screws again. Then set the correct height by loosening the two bolts with an Allen wrench [B] so it can turn, shift the arms into the correct position, and then tighten the screws again.
- Page 13 Flashing light system To use the flashing lights press the switch to left or right. The turn indicators work on batteries located in the two front lights. To replace the batteries, turn the screw on the cap and take the orange cap [B] away. Then remove the PCB [C] from the holder.
- Page 14 Rear steering The person in the rear steers the bicycle, the handlebars in the front are fixed. Speed hub co-driver The main driver can adjust the co-biking of the co-driver with the speed hub. There are two positions: The pedals of the co-driver are moving together with the pedals of the main driver.
- Page 15 deAkkus User manual Tandems 14.10...
- Page 16 To charge the battery: For the best performance and to prolong the life of the battery, we recommend that you charge the battery at home at room temperature. 1. Open the little lock by turning the key a quarter (to the right). 2.
- Page 17 Put the battery back in the holder. Slide it behind bar [A] and press it firmly on strip [B]. 10. Pull the handle backwards and push the battery on the top to the connector as shown in the drawing and close the lock. 11.
- Page 18 Make sure that the switch is set to the side the battery is placed. Backup battery (optional) The bike can be supplied with a second battery. To activate the second battery (when the first battery is empty) turn the switch under the luggage carrier to the right sight in order to activate the second battery.
- Page 19 Twinny Plus and Kivo tricycle: Charging the Battery: For the best performance and to prolong the life of the battery, we recommend that you charge the battery at home at room temperature. To charge the battery: 1. Open the little lock by turning the key a quarter (to the right) 2.
- Page 20 Backup battery (optional) The bike can be supplied with a second battery. When the connected battery is empty, switch the two batteries. Ensure that the battery is always is pushed straight into the holder. If desired, you can leave the second battery of the bike to charge when you are using the other.
- Page 21 Beware: Never stall the bike with an empty battery. We advise to charge the battery as soon as possible when it’s totally empty. Only charge the battery with the supplied charger! Make sure that the battery is not charged at a temperature lower than 5ºC. We advise to charge the battery at room temperature.
-
Page 22: Before First Use
Parking brake Always use the parking brake if you park the bicycle and leave it behind. If you are using the Twinny Plus and Kivo tricycle, use the parking brake when you get on or off the bicycle. Lighting... - Page 23 Remove the two screws at the back side of the front light. Remove the rear cover by using your thumb and index finger on the spot of the cavity in the side of the front cover by pressing on it. Replace alkaline batteries (1.5V - 1500mA) and replace the rear cover.
- Page 24 Rear light The rear light has three options which you can choose by pressing the button repeatedly: On- Auto-Off. The setting is as follows: Press 1x: light is on Press 2x: lighting is automatic 1x = ON 2x = AUTO Press 3x: light is off 3x = OFF In the "On/Off"...
- Page 25 Small obstacles should be cycled over with appropriate speed. Obstacles higher than 5 cm should be avoided. Extra safety points for the Twinny Plus and Kivo tricycle The tricycle gives a very different ride experience than a bicycle with two wheels! Practice, in particular, with bends and braking, because a tricycle can react contrary to what you would expect.
-
Page 26: Technical Details
There are two chains on the bicycle. The chains should not be too tight. They should hang loose. Without effort you should be able to move the chain up and down, half a centimetre approximately. Chain Twinny en Kivo: To keep the chain tension correct, the back wheel axle is adjusted. Follow the instructions... - Page 27 Chain Twinny (Plus) and Kivo (tricycle): To keep the chains on the front of the bicycle tight, secure two chain tension wheels on the bike. Follow the instructions below to adjust the chains to the correct tension so the chain tension wheels do not become loose: Loosen the cap nut a few turns.
- Page 28 Cleaning The frame of the bicycle can be cleaned with a damp cloth. For lightly soiled areas, you can use a mild detergent. The wheels can be cleaned with a damp brush with plastic hairs (not a wire brush!) The grips and the saddles can be cleaned with mild soap and water.
-
Page 29: Repairs And Maintenance To Be Done By Dealer
Repairs and maintenance to be done by dealer It is recommended that the bicycle has a yearly inspection carried out by the dealer. In the event of technical trouble or faults, the bicycle should be taken to the dealer for repairs immediately. -
Page 30: Frame Number
Frame number The frame number is printed on the sticker. This sticker is located on the frame. An example is shown here. The position of the sticker: On the saddle tube On the saddle tube On the saddle tube On the saddle tube Please fill in the details of your bike: Date .