Vanraam Easy Go User Manual page 22

3. Take the battery pack inside. First plug the charger
into the socket. The green LED will light up. The
charger is now on standby.
4. Then insert the connector of the charger into the
charging point of the battery. The red LED will light
up. The charger is now charging.
Please note! If the battery is not connected
properly, the green LED will light up (standby
mode). If the connection is poor, unplug the plug
from the socket and clean the charger's
connector with a dry cloth.
5. The charging time depends on the level of the
battery. The charging time is about 2 hours for a
10.7 Ah and about 4,5 hours for a 24.8 Ah battery.
6. Once the battery is fully charged, the green LED will
be solid. Now first remove the charging connector of
the charger from the connector of the battery.
7. Then unplug the charger from the socket.
8. Put the battery back in the holder of the cycle and
close the lock.
If necessary, the battery can also be charged directly on
the cycle.
Charger:
LED indication
Green
Red
Green
Red, blinking
Version 21.01
Status
Standby
Charging
Battery full
Safety: Polarity inversion; Short; Over temperature; Over power;
Over voltage
3.
4.
22/43