GEL DOSAMATIC PP Installation, Use And Maintenance Manual page 53

Which parameters must be set?
mode (02)
% (percentage of product quantity to dose)
divide
CONC (% of product concentration)
Impulses from water meter
Tasto
CC/Stroke
TIMEOUT
Use "UP" key to change selected unit ("_" blinking cursor).
DIVIDE
To move to next digit (unit) press "RIGHT" key.
150.00
To modify the "Conc" concentration value press "P" key.
Use "UP" key to change selected unit ("_" blinking cursor).
To move to next digit press "RIGHT" key.
Press "P" key to save the entered value and "ESC" to exit
to main menu, or only press "ESC" to exit without saving.
mode ( 02)
divide
Note: For the proper working of this mode make sure you
mode ( 03 )
have set the parameter "TIMEOUT". "Timeout" is operating
Tasto
when the calculation result is a multiplication.
multiply
Tasto
5.6 "MLQ" working mode
DIVIDE
The impulses supplied by a water meter connected to the pump determine the dosage according to MLQ
value, product concentration and quantity per stroke set during programming.
150.00
multiply
When to use this mode?
This mode is useful when an external signal sending impulses (water meter with impulse sender) is
010.00
available; it is necessary to properly dose a product in the set quantities, by specifying only MLQ (millilitres
per quintal). The pump will control incoming impulses.
Which parameters must be set?
MLQ (product quantity in millilitres per quintal)
mode (03 )
CONC (% of product concentration): set 100% if the product is pure
CC/STROKE (see page CC/ST)
multiply
mode (04)
WMETER (water meter with impulse sender)
Tasto
TIMEOUT
PPM
Tasto
Use "UP" key to change selected unit ("_" blinking cursor).
To move to next digit (unit) press "RIGHT" key.
multiply
To modify the "Conc" concentration value press "P" key.
010.00
Use "UP" key to change selected unit ("_" blinking cursor).
ppm
To move to next digit press "RIGHT" key.
0003.00
Press "P" key to save the entered value and "ESC" to exit to
main menu, or only press "ESC" to exit without saving.
Tasto
conc %
mode ( 04)
010.0
PPM
Tasto
ppm
Note: For the proper working of this mode make sure you have set the parameter "TIMEOUT". "Timeout" is
0003.00
operating when the calculation result is a multiplication.
Tasto
conc %
010.0
mode ( 05 )
PERC
Key
Tasto
Selectable from
perc
0.1 to 10.0%
03.0
Key
Tasto
conc %
mode (05)
010.0
PERC
Tasto
perc
mode (06)
03.0
MLQ
Tasto
Tasto
conc %
MLQ
010.0
03.00
Tasto
conc %
mode (06)
010.0
MLQ
Key
Tasto
MLQ
03.00
Key
Tasto
conc %
010.0
53