Nilfisk-Advance SH AUTO Series Instructions For Use Manual page 21

Original Instructions
Running with hard water (>15° dH) without the optional "Water
softening device", the wax-conservation will not be of good
quality. Thus we recommend that program step 5 is discon-
nected and turned into an extra STOP function by closing the
switch S11 (OFF).
The "Active wax" detergent in container "B" must be replaced by the
"Auto Dry" detergent (see sec. 4.1.6), and the wash sequence for a
medium size car will be the same as in the previous programs 1, 2,
3, 4. Upon application of "Auto Dry" in program 4, do not rinse it off.
Program 4 - (use approx. 3
minutes).
- Hot (or Cold) Conservation
with wax, low pressure and
detergent "B".
Apply wax over entire bo-
dywork, and leave on for ap-
prox. 1 minute.
Program 5 - (use approx. 2
minutes).
- Cold (or Hot) High pressure
fl ushing without detergent.
Flush off remainders of wax.
STOP
- Always place the Selector
switch in this position when
cleaning is completed.
NOTE: The owner can individu-
ally assign hot or cold to each
program step (section 4.1.7).
NOTE: Always place the lance
in the lance holder, in order for
the circulation frost protection
system to work.
SH AUTO
21