Table of Contents
Advertisement
SH AUTO
5.5 Cleaning of high
pressure nozzle
5.6 Fuel fi lter
5.7 Disposable waste
26
A clogging up in the nozzle will cause the pump pressure to in-
crease above normal operating pressure, and cleaning of the
nozzle is required immediately.
1. Stop the cleaner and detach the spray lance by loosening the
screw on the quick connector.
2. Clean the nozzle with the cleaning tool.
IMPORTANT: ONLY use the cleaning tool when the spray lance
is detached.
3. Flush the spray lance backwards with water.
4. If the pressure is still too high, repeat items 1-3.
This high-pressure hot water washer consists of parts, which can
affect the environment when thrown away. Parts that can pollute
are as follows:
Oil, painted/zinc-coated parts, plastics/plastic-coated parts.
Therefore, it is important to follow the laws concerning the removal
of polluting and dangerous materials when replacing spare parts or
disposing of high-pressure hot water washer.
It is recommended that you bring the rejected parts to waste dis-
posal areas or recycling plants that are approved for the destruc-
tion of these types of materials.
Open the door to gain access to
the fuel pump.
If the fi lter on the suction side of
the fuel pump is clogged up, it
must be replaced.
Original Instructions
Advertisement
Table of Contents
