Clatronic DVD 552 HC Instructions For Use Manual page 44

DVD 552 HC - GB 21.03.2003 8:58 Uhr
BEFORE YOU CALL THE SERVICE TECHNICIAN...
If the device fails to function normally, this does not necessarily mean it is defective. Please use the following list to check
whether the malfunction has a simple cause. Never open the cabinet to look for a fault. This invalidates the guarantee re-
sulting in the manufacturer accepting no liability.
Fault
Blank display after
switching on
No picture
Picture is distorted.
Distorted picture or no
colour in the DVD menu
CD cannot be played.
No sound
No screen menu when
the CD is removed
Device does not react
to the remote control or
reacts incorrectly.
Distorted or black and
white picture with DVD
or video CD
No sound
from digital output
Device does not react
to pushbuttons
44
Seite 44
Possible cause
• Mains cable not plugged in correctly
• No power at the socket
• Device not switched on
• TV set switched off
• Wrong channel on the TV set
• DVD player is connected incorrectly or
the connection cable is defective
• CD dirty
Note: Light distortion can sometimes ari-
se when there is no mail function.
• Colour system has been set incorrectly
• The CD was inserted with the wrong si-
de up.
• CD dirty
• CD defective
• Volume has been set too low or mute
function is active.
• Audio connections not made correctly.
• Sound source has been incorrectly sel-
ected or not switched on.
• Speaker cable has not been connected
correctly.
• Internal safety Mechanism is active.
• Device is not receiving the signals
• Batteries too weak
• Faulty signal due to light sources such
as fluorescent lights or energy-saving
lights
• Faulty signals due to other remote con-
trol devices
• Incorrect CD format
• Incorrect connection
• Incorrect audio format has been selec-
ted.
• Internal safety mechanism is active.
Troubleshooting
Check the mains cable.
Check the supply voltage.
Press »POWER« button 6
Switch on the television set.
Set the correct channel (AV).
Check the connection. See page 28
Clean the CD. See page 43.
Note: The DVD receiver should be
connected directly to the television; do
not connect via the video recorder.
Checking the VIDEO OUT connection
type setting
Check the inserted CD. The side to be
played must point down.
Clean the CD
Try another CD.
Increase volume using the
»ADJ/VOL. +/-« 5/40 buttons.
Check the connections (see page 28-30)
Check the sound source; try another
playback source.
Check the connections ( see page 28)
Turn the machine to standby using the
>>POWER<< 6 button.
Move obstacles out of the way.
Check batteries and replace if necessary.
Check foreign light sources.
Remove the batteries from other remote
control devices.
Check the format of the CD by looking at
the cover. This device is only suitable for
PAL and NTSC.
Check the connections. See page 28
Check whether the audio format of the
selected audio language corresponds to
the possibilities of the receiving device.
Turn the machine to standby using the
>>POWER<< 6 button.