Clatronic DVD 552 HC Instructions For Use Manual page 32

DVD 552 HC - GB 21.03.2003 8:58 Uhr
40 ADJ/VOL +/ -
For setting the required volume
41 I SLOW
Playback in slow motion
MEMORY
Tuner memory button
42 SELECT
Selects the individual sound channels for setting the
volume
43 LISTENING
Sets the LISTENING Mode such as Dolby Surround
or Dolby 3 Stereo.
Operating with the remote control:
Identicallabelling on the remote control transmitter and
the dice means that these have the same function (e.g.
button 12 on the device or button 43 on the remote con-
trol is described by »button 12/43«).
When operating the device using the remote control,
please observe the following:
– Aim the remote control. (transmitter) at the remote
control receiver 3 on the device..
– You must have a clear view between the transmitter
and the receiver..
– If the range of the remote control begins to be impai-
red, then you should replace the batteries.
PUTTING INTO OPERATION AND BASIC FUNCTIONS
Menu functions
All operations of the DVD operating mode are shown on
the screen in »MENU-Form« for simpler operation.
Various languages can be selected for the menu. To set
the menu language, please refer to the »Basic settings«
section on page 33.
In all menus, the selections and the settings are made
using the buttons » /
firmed by pressing »ENTER« 21.
The TEST-TONE option, for example, is explained as
follows...
SETUP MENU-MAIN PAGE SPEAKER SETUP
...then these operating Steps are to be carried out.
- Press the button »SETUP« 20 so that the SETUP
MENU-MAIN PAGE appears on the screen.
- Use the » « button 21 to select the line SPEAKER
SETUP.
- Call up the SPEAKER SETUP by pressing the »ENT-
ER« 21 button.
- Use the » « button 21 to select TEST-TONE
- Press the » « button, the marking now switches to
the right side of the menu into the set-up mode.
- Highlight the required setting using the » / «
buttons.
- Confirm the setting using the »ENTER« button 21.
- To leave the menu, press the »SETUP« button 20.
32
Seite 32
/ / « 21. The setting is con-
TEST TONE
Replacing the batteries:
Caution!
The batteries from the remote control should be kept
away from children. Swallowing batteries can result in
serious injuries to health.
Normal batteries must not be charged, heated up or
thrown into open fires (danger of explosion)
If the remote control is not used for a longer period of ti-
me then the batteries should be removed. The remote
control could otherwise be damaged battery acid.
If there is SETUP menu on the screen then the other de-
vice functions
I If a command can not be executed because, e.g.
the CD does not contain a given piece of informati-
on, then this symbol appears on the top left corner
of your screen.
Switching the device on and off
Switch on the television. If the DVD receiver is connected
to the television by SCART then switch over to the
respective Scart input if necessary.
If the DVD receiver is connected to the television via the
VIDEO or S-VIDEO socket then the corresponding video
input must be selected at the television.
Switch on the DVD receiver with the »POWER« button 6.
Display 10 of the DVD receiver now lights up and you are
prompted an the television screen to insert a CD.
If a CD is already inserted, please press the
» II PLAY« button.
Switch the device to standby mode by pressing the
»STANDBY« button 14 LED 7 lights up now. Re-pressing
»STANDBY« button 14 or »SOURCE« button 13
switches the device back on from standby mode.
Note: Depending on the reception conditions of your tele-
vision, it is possible that there is disturbance to the pictu-
re when watching normal television. In this case, switch
off the DVD receiver using the »POWER« button 6.