Clatronic DVD 552 HC Instructions For Use Manual page 34

DVD 552 HC - GB 21.03.2003 8:58 Uhr
Keep one of the »TUNING +/ -« buttons 24 pressed until
the frequency in display unit 10 automatically changes.
When a station is sufficiently strong, the search is
stopped and the station is simultaneously optimally set
and displayed. When an RDS signal is transmitted, the
name of the station appears in the display.
To store the station, press »MEMORY« button 41.
Set the desired channel position using the »PRESET +/ -
« button 23 or the numeric keys 19.
Re-press »MEMORY« 41 to confirm your entry.
To store additional programs, repeat the above steps.
Note:
– If, after pressing the »MEMORY« button, no button is
pressed for 5 seconds then the device switches back
to the normal frequency display.
– You can set stations with a weaker signal by repeated-
ly pressing the »TUNING +/ -« button 24.
Listening to radio
Switch on the device using the STANDBY switch
»POWER« 6. Use »TUNER« 28 or »SOURCE« 13 to
switch to tuner mode and select the desired frequency
band (FM of AM).
The previously stored channel positions can be selected
using the numeric buttons 19 or the »PRESET +/ -« but-
ton 23 . Set non-stored stations using the »TUNING +/ -«-
buttons 24.
CONFIGURING AND OPERATING THE SURROUND SYSTEM
Adjusting the loudspeakers
The volume of the speakers can be manually set for each
individual speaker connected to the system. During this
procedure it is also possible to adjust the high tones
(treble) to your personal taste.
34
Seite 34
The device switches between stereo and mono reception
when you repeatedly press »ST/MO« 39. In case of bad
reception, we suggest that you switch to MONO.
By repeatedly pressing »DISPLAY« button 34, the device
switches between station names, program type and
transmission frequency.
Inserting and removing a CD
DVD Video CDs, Video-CDs, MP3-CDs and Audio-CDs
can be played back on this device. The device automati-
cally recognises the corresponding format after reading-in
the CD. Playable CDs are marked with one or more of the
following logos.
Switch on the DVD receiver and switch to DVD mode.
Then press »OPEN/CLOSE« 9/37. The CD tray 8 is ope-
ned. Now insert the CD with the side to be played facing
downwards. The side to be played is blank. If both sides
are bland (e.g. in case of some DVDs that are recorded
on both sides), then first play back the side that is marked
with A or a 1, depending on the CD. Single CDs (8cm)
without adapter can also be inserted.
Now close the CD tray by re-pressing »OPEN/CLOSE«
9/37. The machine immediately begins to play back
DVDs. For CDs please press "PLAY".
Warning!
To avoid damage to the device, no foreign objects must
enter the CD tray.
Note: This DVD receiver supports the copy-protection
codes of most DVDs and video CDs. This means that the
contents of these CDs can not normally be copied by a
video recorder onto tape during normal playback.
The following abbreviations are used for each of the so-
und channels (speakers).
FL
C
FR
SR
SL
SUB
Press the DISPLAY button several times.
Front speakers Left
Centerbox (speaker middle)
Front speaker Rright
Surround speaker Rright
Surround speaker Left
Subwoofer