Clatronic DVD 552 HC Instructions For Use Manual page 33

DVD 552 HC - GB 21.03.2003 8:58 Uhr
Selecting the operating mode
For playback of picture and sound, the corresponding
operating mode must be selected. The respective opera-
ting modes can be selected directly using the buttons
»DVD«, »TUNER« or »AUX/TV« 28. The individual ope-
rating modes are run through by pressing the
»SOURCE« button 13.
DVD Playing-back from the built-in DVD compact disc
Player
TUNER Radio operation selecting the frequency band
AUX 1 Playback from a device connected to one of
AUX 2 the »AUDIO IN AUX 1/2« sockets 52.
Display 10 is used for control purposes..
Setting the volume
By pressing the »ADJ/VOL. +/-« buttons5/40, you can set
the volume as desired.
To switch off the sound, press the »MUTE« button 36 on
the remote control.
On re-pressing this button or one of the »ADJ/VOL +/-«
5/40 the sound is switched back on.
Basic settings
The following settings only need to be carried out once
before putting the system into operation for the first time.
Before changing the basic settings (in the General Set-
up), check which corrections are required based on the
following table.
Menu display:
Menu language OSD LANG
Video output VIDEO OUT
Menu language (OSD LANG):
Select between GERMAN, ENGLISH, FRENCH,
ITALIAN, and SPANISH
Video output (VIDEO OUT):
Select...
SCART, when »SCART OUT« 46 is connected to the te-
levision.
S-VIDEO, when »S-VIDEO OUT« 47 is connected to the
television.
Setting the menu language (OSD LANG):
Switch on the device using the STANDBY switch
»POWER« 6. If necessary, select the video input at the
television. Switch to DVD operation by pressing the
»DVD« button 28.
Press »SETUP« 20. The SETUP MENU-MAIN PAGE ap-
pears on the screen. The GENERAL SETUP line is high-
lighted.
Seite 33
Factory setting:
ENGLISH
SCART
SETUP MENU – MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
By pressing the »ENTER« button 21, GENERAL SETUP
will appear.
GENERAL PAGE
TV DISPLAY
VIDEO OUT
OSD LANG
MAIN PAGE
Using button » « select OSD-LANG to change the menu
language.
GENERAL PAGE
TV DISPLAY
VIDEO OUT
OSD LANG
MAIN PAGE
Press » « 21and highlight the desired language with
» / « 21.Confirm the setting with »ENTER« button 21.
Press »SETUP« 20 to leave the menu.
Setting the video output (VIDEO OUT)
(Proceed the same as when setting the menu language;
the device must be switched on and in DVD operating
mode).
- Press the »SETUP«20 button until SETUP MENU-
MAIN PAGE appears. The GENERAL SETUP line is
highlighted.
- Press »ENTER« 21; the GENERAL SETUP appears.
- Use » « button 21 to select VIDEO OUT.
GENERAL PAGE
TV DISPLAY
VIDEO OUT
OSD LANG
MAIN PAGE
- Press » «.
- Use the » / « to select the video output.
- Press »ENTER« button 21 to confirm your selection.
- Use »SETUP« button 20 to leave the menu.
Setting and storing the radio stations
Switch on the device using the STANDBY switch
»POWER« 6. Use »TUNER« 28 or »SOURCE« button 13
to switch to tuner mode and select the desired frequency
band (FM or AM).
FM 87,5 MHz – 108,0 MHz
AM 522 kHz – 1620 kHz
NORMAL/PS
NORMAL/LB
16:9
GERMAN
ENGLISH
FRENCH
ITALIAN
SPANISH
S-VIDEO
SCART
33