Ap302W Power Source; Status Led Activity And Light Sensor - Extreme Networks ExtremeWireless AP302W Installation Manual

AP302W Overview

AP302W Power Source

Learn about the access point power source and the power ports usage.
Power source
PoE at 802.3at
802.3af
External 12 VDC power
supply (optional;
ordering part #37215-
PWR 12 VDC, 2A, 2.5
mm x 5.5 mm
connector)
Note
PoE power is disabled when external power supply is used.

Status LED Activity and Light Sensor

Details about access point status LED activity and front face light sensor.
The light sensor is located in the front face of the access point but is not visibly marked. The status LED
is located at the bottom of the access point and conveys the access point operational status for system
power. For more details about access point front and rear features and port information, see
Features on page 10.
Table 7: Status light activity
Status light color
Green
Amber
Dark
Description
802.3at is provided
through ETH0
802.3af is provided
through ETH0
Power is provided
through an external DC
power supply plugged
into an AC source
Activity
Steady
Slow blinking
Steady
Slow blinking
Fast blinking
None
PSE port (up to 12.5 W)
Yes
No
No
Description
The device has a Control and Provisioning of
Wireless Access Points (CAPWAP) connection to
ExtremeCloud IQ and is operating normally
The device has a CAPWAP connection to
ExtremeCloud IQ, but is operating on 802.3af
power instead of 802.3at power
The device is initializing, rebooting, or is running
without a CAPWAP connection
The device has no CAPWAP connection to
ExtremeCloud IQ, and is operating on 802.3af
power instead of 802.3at power
The device is upgrading it's IQ Engine firmware
Power is off or the status indicator is disabled
ExtremeWireless™ Access Point AP302W
AP302W Power Source
USB port (2.5 W)
Yes
Yes
Yes
AP302W
15