Circontrol Post eVolve Series Installation Manual page 6

Post eVolve Series Installation Manual
2
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
The charge point is designed for installation in indoor and outdoor areas. For each of
the different conditions of installation, the unit must be installed safely and ensure
adequate protection.
• Charge point must not be installed
in areas where there is potential
risk of explosions.
• Do not install the charge point
where falling objects may damage
the equipment.
• The surface where the charge
point is placed must withstand the
mechanical forces.
• Do not use this unit for anything
other
charging modes contemplated in
IEC 61851.
• Do not modify this unit. If modified,
CIRCONTROL
responsibility and the warranty
will be void.
• Comply strictly with electrical
safety regulations according to
your country.
Refer to TECHNICAL DATA section for more information about environmental
installation conditions.
04
Read carefully all the instructions before starting in or-
der to ensure properly installation of the charge point.
than electric vehicle
will reject all
• Do not make
manipulations with
energised.
• Only trained and
personnel should have access to
low-voltage electrical parts inside
the unit.
• Check the installation annually by
qualified technician.
• Remove from service any item that
has a fault that could be dangerous
for users (broken plugs, caps that
don't close...).
• Use only Circontrol supplied spare
parts.
• Do not use this product if the
enclosure or the EV connector is
broken, cracked, open, or shows
any other indication of damage.
repairs or
the unit
qualified