Separately Ordered Components; Ap3965 Installation Procedures - Extreme Networks ExtremeWireless AP3965i Installation Manual

3 Perform a visual inspection of the AP3965 for any signs of physical damage. Contact Extreme
Networks if there are any signs of damage.

Separately Ordered Components

The following accessories are available for the ExtremeWireless Access Point AP3965. For ordering
information, contact Extreme
•
Antennas. Refer to
Preparation and Installation Guide
available at: https://extremenetworks.com/downloads
•
Power over Ethernet (PoE) Injector. The following 802.3at PoE injectors are recommended for use
with the AP3965:
•
PD-9001GO-ENT (outdoor 802.3at PoE single port midspan)
•
PD-9501GO-ENT (single port 802.3at plus outdoor midspan)
Note
When the AP3965 is powered by the Power Injector, the DATA port of the injector should
be connected to a non PoE switch or, if the switch is PoE capable, PoE must be DISABLED
on the DATA port.
•
Terminator cap. This part is listed as an optional accessory for the AP3965e. If you are not attaching
eight antenna feeds to the AP3965e, you must use a terminator cap on the antenna connector(s)
not being used.
•
WS-CAB-NTERM — Terminator, Standard Polarity, Type-N Plug, 50 OHM, 1W
•
Cables to connect the lightning protectors on the enclosure to the antennas. All cables listed below
have Standard Polarity Type-N jack and plug connectors:
•
WS-CAB-L200C20N—20 foot LMR200 cable
•
WS-CAB-L400C06N—6 foot LMR400 cable
•
WS-CAB-L400C20N—20 foot LMR400 cable
•
WS-CAB-L400C50N—50 foot LMR400 cable
•
WS-CAB-L400C75N—75 foot LMR400 cable
•
WS-CAB-L600C25N—25 foot LMR600 cable
•
WS-CAB-L600C50N—50 foot LMR600 cable
•
Bracket (30514) WS-MBO-ART01 — Outdoor articulating mounting bracket for AP3965.

AP3965 Installation Procedures

Use these instructions as guidelines for mounting and connecting the AP3965 easily and safely. The
installation of the AP3965 should be performed by a professional installer to ensure proper operation
and compliance with local safety guidelines.
Attach the AP3965 to a surface that can support it and withstand its environment. It can be mounted to
a wall, girder, ceiling, or pole, and the surface material can be concrete, brick, wood, metal, or plastic.
Warning
This product should be installed and serviced by a qualified licensed technician, electrician, or
electrical maintenance person familiar with its operation and the hazards involved.
ExtremeWireless™ AP3965i & AP3965e Installation Guide
Networks.
External Antennas on page 34 and the
for more information about these antennas. This document is
ExtremeWireless External Antenna Site
.
Installation
12