Extreme Networks ExtremeWireless AP3965i Installation Manual page 13

Install the AP3965 by following these procedures:
•
Ground Connection
•
Mounting the AP3965 to a Wall
•
Attaching the Mounting Bracket to the AP
•
Mounting the AP3965 to a Pole
•
Attaching Antennas
•
LAN 1/LAN 2 Connections
•
Weatherproofing the Antenna
•
Forming a Drip Loop for AP3965e Cables
Ground Connection
The ground connection for the AP3965 is located on the rear of the device. Attach a ground to earth
cable to the grounding terminal.
1 Use the M4 ground screw assembly, with the star washer, to attach the ground wire's ring terminal to
the AP. The wire should be as close to the AP bottom as possible (see
Terminal Location
2 Tighten the screw to a torque of 12.0 in-lbs.
Figure 2: AP3965 Ground Terminal Location
Mounting the AP3965 to a Wall
Mount the AP so that the glands are on the side of the AP closest to the ground, and not above the
plastic cover. You must provide a 3-inch drip loop on all cables. For more information, see
Drip Loop for AP3965e Cables
1 Using the mounting bracket as a guide, mark the location for the mounting screws on a wall.
ExtremeWireless™ AP3965i & AP3965e Installation Guide
on page 13
on page 13
on page 14
on page 15
on page 21
on page 21
on page 24
on page 25
on page 13).
on page 25.
Installation
Figure 2: AP3965 Ground
Forming a
13