Extreme Networks ExtremeWireless AP3965i Installation Manual page 21

Attaching Antennas
Install the external antennas intended for area coverage. For information about antenna selection and
installation, refer to the
Note
The total number of required antennas and associated port locations on the AP3965 depends
on the coverage area and the type of antennas selected.
To attach external antennas to the AP3965:
1 Attach the external antenna cables to the Standard Polarity Type-N connectors on the AP3965. All
the antennas can be extended away from the AP using the optional cables.
2 Place a terminator cap on any antenna connectors that will not be used (see
Terminator Caps
3 Do not install the AP with the antennas pointing upward. If the AP is vertical, the recommended
installation is with the glands pointing down. If the AP is horizontal, the recommended installation is
with the glands located be closest to the ground. In both cases, we recommend that the antennas be
extended horizontally.
Figure 10: Installing Terminator Caps
LAN 1/LAN 2 Connections
The AP3965 has two LAN ports (LAN 1 and LAN 2). Refer to
the location of these ports. Before connecting an RJ45 cable (not provided) to either port, a waterproof
cable gland adapter assembly must be installed onto the cable.
ExtremeWireless™ AP3965i & AP3965e Installation Guide
ExtremeWireless External Antenna Site Preparation and Installation
on page 21).
Figure 10: Installing
Figure 1: AP3965e Front View
Installation
Guide.
on page 9 for
21