Table of Contents
Advertisement
3
Installation
Unpacking the AP3965
Separately Ordered Components
AP3965 Installation Procedures
Weatherproofing the AP3965e Connections
Configuring AP3965 Channel Settings
This chapter provides general information about the ExtremeWireless Outdoor Access Point AP3965.
Unpacking the AP3965
Unpack the AP3965 as follows:
1
Open the box and remove the packing material protecting the AP3965.
2 Verify that the contents of the carton contains the items listed below.
Table 4: Contents of the AP3965 Carton
Quantity
1
1
Under the cardboard separation:
1
1
1
The following hardware is included:
4
4
4
4
8
1
Optional: You may also need antennas, terminators, or cables. Refer to
Components
on page 12 for product numbers.
Note
Before mounting the AP3965, read the
ExtremeWireless™ AP3965i & AP3965e Installation Guide
Item
AP3965 Quick Reference
AP3965i/e model that you ordered.
H-shaped bracket that is used for mounting the AP.
Metal bracket for attaching the AP to a pole, pipe, or mast.
#10AWG ground wire with a ring terminal crimped on it (6 foot length)
Additional Hex nuts for the concrete anchors.
Concrete wall anchor assemblies that include the anchors, a flat washer, and a hex nut.
Split Washers for the concrete anchors.
Cable clamps, all are ½" wide. Two clamps accommodate a 2.5" maximum diameter pole and
two clamps accommodate a 6"-7" diameter pole.
Screw assemblies, size M4, that include the screws, flat washers, and split washers.
Ground Screw assembly, size M4, that include the screw, star washer, and split washer.
Separately Ordered
RF Safety Distance
on page 48.
11
Advertisement
Table of Contents
