Extreme Networks ExtremeWireless AP3965i Installation Manual page 25

Figure 12: Weatherproofing the AP3965e Antenna
1 Antenna
2 Nut
3 Standard polarity Type-N plug
To weatherproof the antenna (refer to
1 Secure the antenna in place by tightening the single nut (item 2).
2 Seal the connection between the Type-N jack (item 4) of the AP3965e and the Type-N plug (item 3)
of the antenna by wrapping a layer of sealing tape (item 6).
Forming a Drip Loop for AP3965e Cables
Once the cables have been connected to the AP and the connections have been weatherproofed,
gather each cable below the AP, and form a drip loop as shown in
on page 26.
Note
The drip loop prevents water from entering the AP by channeling water down and away from
the connection points. Drip loops are required to ensure proper operation of the AP.
ExtremeWireless™ AP3965i & AP3965e Installation Guide
4 Standard polarity Type-N jack
5 AP3965
6 Sealing tape (recommended, but not supplied)
the figure above):
Figure 13: Drip Loop for the AP3965e
Installation
25