Flash On Time - Datalogic DSM0400 Product Reference Manual

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Scan the bar code: SELECT FLASH ON TIME SETTING on
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 1. Flash On Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2 leading zeroes to yield two
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH ON TIME SETTING
Scan Two Characters From
5
Appendix C
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
ming Mode.
ing the duration which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
NOTE
Mode.
EXAMPLES
500ms
05
'0' and '5'
1,000ms (1 sec.) 5200ms (5.2 sec.)
10 52
'1' and '0' '5' and '2'
Scanning Features
page 63
Appendix C represent-
9,900ms (9.9 sec.)
99
'9' and '9'
219