Dotcode Minimum Dot Diameter - Datalogic DSM0400 Product Reference Manual

DotCode Minimum Dot Diameter

This feature specifies the minimum dot diameter of a DotCode to be decoded:
the measurement unit is pixel and it refers to the diameter of the dots as they
appear on the acquired image. Characters can be set from 0001 to 0512 in
increments of 1 (pad with zeroes). Always use four digits (e.g.: scan the bar-
codes '0', '0', '0', '2' for setting diameter = 2). Default value is 0001.
Minimum Dot Diameter
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
Product Reference Guide
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
character(s). End by scanning the ENTER/EXIT bar
code again.
0001 = Minimum Dot Diameter is 1 pixel
Enter/Exit Programming Mode
Appendix C
representing your desired
CANCEL
185