Dotcode Set Length 1 - Datalogic DSM0400 Product Reference Manual

DotCode Set Length 1

Specifies one of the bar code lengths for DotCode. Length 1 is the minimum
label length if in
Length on page
(default: 1) in increments of 0001 (pad with zeroes). Always use four digits
(e.g.: scan the barcodes '0', '0', '0', '2' for setting length = 2). See "Set Length"
on Chapter 4, References
Select DotCode Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Variable Length on page
180. Characters can be set from 0001 to 9999 characters
for more detailed programming instructions.
0001 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
180, or the first fixed length if in
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
Appendix C
characters in
character(s). End by scanning the ENTER/EXIT bar
code again.
CANCEL
Fixed
representing your desired
181