Datamax M-Class Mark II Operator's Manual page 84

1 3 ) LABEL W I D TH
Set s t he label widt h.
Possible Va lu e s:
Range: 75 – 426; default =
* 426
( Unit s = .01 inch)
1 6 ) PRESEN T D I STAN CE
Set s label st opping ( and in
cert ain cases t he st art ing)
locat ion for different print er
configurat ions.
Possible Va lu e s:
* AUTO ( Aut om at ically set s t he
st op locat ion. I nst alled
opt ions will be 'aut o-
sensed' and t he
appropriat e st op
posit ion will
aut om at ically be set .
Host com m ands are
ignored.)
HOST ( Set s st op posit ion
according t o opt ions
inst alled. I f no opt ions
are inst alled t he print er
set s st op locat ion t o
t he next label's st art of
print . Host com m ands
will override.)
1 9 ) I N PUT M OD E
Select s bet ween t he st andard or t em plat e
int erpret at ion of incom ing dat a.
Possible Va lu e s:
* DPL ( print er const ruct s t he label using t he
st andard DPL com m ands)
LI NE ( print er const ruct s t he label using a
preloaded t em plat e form )
Appe n dix C – Pa pe r M e n u Se t u p
1 4 ) SCALABLE FON T
Set s t he num ber of m em ory
blocks t o allocat e for scalable
font s.
Possible Va lu e s:
Range: 0 – 128; default = * 64
( Unit s = 4K Byt es)
1 7 ) LABEL ALI GN M EN T
Set s t he label alignm ent m et hod.
Possible Va lu e s:
YES ( user m anually det erm ines
'ALI GN LENGTH')
AUTO ( print er det er m ines 'ALI GN
LENGTH')
* NO ( no Label Alignm ent used)
2 0 ) D PL EM ULATI ON
This inst ruct s t he firm ware t o process specific DPL
dat a ( St art of Print , DPI , and I m aging funct ion)
according t o t he select ed print er em ulat ion.
Possible Va lu e s:
* STANDARD
ALLEGRO ( Allegro Em ulat ion)
P PLUS ( Prodigy Plus Em ulat ion)
PRODI GY ( Pr odigy Em ulat ion)
1 5 ) I N TERN AL M OD ULE
Set s t he num ber of m em ory
blocks t o allocat e for t he int ernal
RAM m odule.
Possible Va lu e s:
Range: 0 – 128; default = * 128
( Unit s = 4K Byt es)
1 8 ) ALI GN M EN T LEN GTH
Leading edge dist ance of t wo
successive labels. Must be ent ered
if 'LABEL ALI GNMENT' is set t o Yes
( see Appendix C.2) .
Possible Va lu e s:
0 – 999; default = 100*
( Unit s = .01 inch)
7 8