Adjusting the value using the numeric buttons
If you already know the new value of the sync offset time which is required, use the
following procedure.
1
Using the numeric buttons, display the required sync offset time on the
LOCATE TIME display.
2
Press and light the STORE button, then press the SYNC OFFSET button.
This saves the value entered in step 1 as the sync offset time.
Note on sector-based synchronized operation
•
If you use variable speed playback or vari-sync playback on the RM-3324/
3348HR master unit, the slave units will follow the varying synchronization.
•
There is a delay of approximately 2 seconds until the slave unit catches up with
the master unit, to establish the servo lock. If you are carrying out auto punch-in/
out operations, this extra time is automatically added to the preroll time.
•
Times shown on the slave unit are the times shown on the master PCM recorder,
after correction by the sync offset time.
Sector-Based Synchronization
45