Time Code Chase Operation - Sony PCM-3348HR Quick Reference

18. Time Code Chase

18-5. Time Code Chase Operation

1
Start playback on the master unit, or alternatively input the external time
code.
2
Ensure that the tape transport on the master and slave recorder units is
stationary, then press and light the TC CHASE button.
Carrying out a chase recording (or rehearsal)
On the RM-3324/3348HR
1
Check that the unit is synchronized or phase re-synchronized to the external
time code.
2
Holding down the REC (or REH) button, press the PLAY button.
On the RM-3324S
1
Check that the unit is synchronized or phase re-synchronized to the external
time code.
2
To carry out a rehearsal, press the REHEARSAL (REC DISABLE) button,
turning it on.
3
Holding down the REC button, press the PLAY button.
This carries out a rehearsal if the REHEARSAL (REC DISABLE) button is lit,
and recording if it is off.
During chase recording (or rehearsal) , changing the sync offset by more than 2
frames, or pressing the FF, REW or STOP button on the master unit cancels the
chase recording (or rehearsal) , and the locate operation begins. After
synchronization to the external time code, chase playback begins.
48
Time Code Chase