Sync/Time Code Window - Sony DMX-R100 Operating Instructions Manual

SYNC/TIME CODE Window

To open this window, touch the SYSTEM button on
the bottom menu bar, then select "TIME CODE" on
the menu.
This window allows you to perform settings of the
synchronous signals and the timecodes to be used for
automation.
1 SAMPLING FREQUENCY buttons
5 TIME CODE READER section
Synchronous signal section
1 SAMPLING FREQUENCY buttons
Touch this button corresponding to the desired
sampling frequency from among 44.1 kHz, 48 kHz,
88.2 kHz or 96 kHz.
Note
When 88.2 kHz or 96 kHz is selected as the sampling
frequency, the frequency range expands to 40 kHz.
However, the following functions are limited. Buttons
corresponding to the limited functions become
disabled even if you touch them.
6 MEASURE/TEMPO section 7 TIME CODE GENERATOR section
• Input channel: The channel number is reduced from
48 to 24.
• AUX Send/AUX Return: The channel number is
reduced from 8 to 4.
• MTR bus: The channel number is reduced from 8 to 4.
• Insertion send: The channel number is reduced from 8
to 4.
• Direct out: The channel number is reduced from 48 to
24.
• Option boards: DMBK-R106 and DMBK-R107
cannot be used.
The DMBK-R104 cannot be used for a channel where
the sample rate converter is set to ON.
2 SYNC CLOCK section
3 PLL status display section
4 CHANGE button
69
Chapter 3 Menu