Fastening The Mount - Kaco blueplanet 87.0 TL3 M1 WM OD IIF0 Manual

Manual
Legend
1 Hood
2 Upper side section
3 Clip lock (4x)
↻ The device is transported to the installation location.
1. Remove the plastic strap from the pallet and packaging.
2. Pull the clip lock off the packaging.
3. Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4. Set the device upright with the base section and side sections.
5. Remove the uppermost side section and base section from the device.
ð If the device is in the correct installation position: Proceed with the installation of the mount.
6.3

Fastening the mount

WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seriously
injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are only
to be used for masonry and concrete.
2. Only install the device in an upright position.
6 1/32"
2 61/64"
B
A
D
C
Fig. 16: Minimum clearances for wall mounting
Legend
1 Mount
2 Fixings for mounting [S12-Ø12mm/ 90mm] *
3 Lock washer
A Minimum clearance: 4.72 In
Recommended clearance: 15.75 In
B Minimum clearance: 11.81 In
C Minimum clearance: 19.69 In
D Recommended clearance: 39.37 In
KACO blueplanet 110 TL3 KACO blueplanet 125 TL3 US
2
1
6
3
4
5
A
Assembly | 6
4 Base section
5 Lower side section
6 Cardboard packaging with mount and mounting kit
21.65 In
17.83 In
18.03 In
41.97 In
2)
1543 mm
1)
18.70 In
1)
10.63 In
1)
18.70 In
1)
10.63 In
Fig. 17: Wall mounting
4 Screw for mounting (4x) [SW 13/ [See sec-
tion 6.3} Page 19]!]
5 Securing screw (1x)
6 Lug to mount the device
1)
Minimum clearance excluding device:10.63 In
1)
Recommended clearance excluding device:18.70 In
- -
- -
²) Recommended clearance with DC breaker:60,74 In
1
5
6
Page 19