Connecting The Interfaces - Kaco blueplanet 87.0 TL3 M1 WM OD IIF0 Manual

Manual
↻ The device has been installed on the mount.
1. Strip the insulation from the equipotential bonding cable.
2. Furnish the stripped cable with an M8 ring cable lug.
3. Lay the cable for equipotential bonding onto the grounding point and attach
with an additional M8 nut and lock washer [ W_17/
4. Check that the connected cable is fitted securely.
ð The housing is included in the equipotential bonding.
7.9

Connecting the interfaces

7.9.1 Overview
DANGER
Risk of fatal injury due to electric shock!
Severe injuries or death may result from improper use of the interface connections and failure to observe pro-
tection class III.
1. The SELV circuits (SELV: safety extra low voltage) can only be connected to other SELV circuits with protec-
tion class III.
CAUTION
Damage to the device from electrostatic discharge
Components inside the unit can be damaged beyond repair by static discharge.
1. Observe the ESD protective measures.
2. Earth yourself before touching a component by touching a grounded object.
All interfaces are located on the communication circuit board (HMI board) inside the housing.
1
Fig. 34: Communication circuit board (HMI board)
1 Communication circuit board
2 USB socket
3 SD slot
4 Ethernet for network connection DHCP
5 RS485 - default
6 DIP switch - activate terminator (2x)
KACO blueplanet 110 TL3 KACO blueplanet 125 TL3 US
88.5 In-Ibs ].
1x RJ 45
PID 24V
2xRJ45 +
GND
9
USB SD Card
-+ -+
2 3
7 INV OFF - connection for remote controls - 24V(+/-
8 ERR connection for external grid protection com-
9 24V 0.5A PID supply (optional)
10 Ethernet – only for starting up by means of static
11 RS485 - connection for string combiner
Installation | 7
Fig. 33: Additional earthing point
1 Earthing bolt
10 6
2x RJ 45 RS485
A
4
5
20%) / 1A (at least 15mA)
ponents (fault signal relay)
IP ( [See section 8.4.2} Page 38])
1
RS485
A
B
GND
11
INV
INV ERR
OFF
OFF
+
-
B A B
GND GND
8
6 7
Page 31