Cycle 4: Cycle Discs At The Carousel; Cycle 5: Cycle Discs Between The Carousel And The Printer - Rimage Professional 3400 Diagnostic Manual

Rimage Professional™ 3400 and 5400N Diagnostic Tests

Cycle 4: Cycle Discs at the Carousel

1. Select diagnostic test 2. Refer to page 3.
2. Make sure the printer tray and recorder trays are closed.
3. Place discs (Qty. 50) in carousel bin 1.

Important! Make sure that carousel bins 2 and 3 are empty.
4. Press button 1 to begin the cycle. The operator panel displays [02 CYCLE TEST CHECKING DEVICES].
The autoloader checks all the carousel bins for discs.
•
The lift arm picks discs from bin 1 and places them in the output bin. This cycle continues until the
•
output bin is full.

Note: The output bin holds 8 discs.
When the output bin is full, the lift arm begins to cycle the discs around the carousel, placing discs in
•
a bin until it is full.
The operator panel displays [02 CYCLE TEST CYCLE = XXXXXX], where X is the number of cycles
•
completed.
5. Press button 1 to stop the cycle and return to diagnostic test mode. The operator panel displays [00
CHOOSE DIAGNOSTIC].
6. Remove the discs from the carousel and the output bin.

Cycle 5: Cycle Discs between the Carousel and the Printer

1. Select diagnostic test 2. Refer to page 3.
2. Select diagnostic test 2. The operator panel displays [02 CYCLE TEST SETUP DEVICES].
3. Press button 2 to open the printer tray.

Important! Make sure that both recorder trays are closed.
4. Place discs (Qty. 50) in carousel bin 1.

Important! Make sure that bins 2 and 3 are empty.
5. Press button 1 to begin the cycle. The operator panel displays [02 CYCLE TEST CHECKING DEVICES].
The autoloader checks all the carousel bins for discs.
•
• The lift arm picks a disc from bin 1, places it on the printer tray, and then places the disc in the output
bin. This cycle continues until the output bin is full.

Note: The output bin holds 8 discs.
When the output bin is full, the lift arm begins to cycle the discs from the printer to the carousel,
•
placing discs in a bin until it is full.
The operator panel displays [02 CYCLE TEST CYCLE = XXXXXX], where X is the number of cycles
•
completed.
7. Press button 1 to stop the cycle and return to diagnostic test mode.
8. Remove the discs from the printer tray, output bin, and carousel.
2001497_A
5