Table of Contents
Advertisement
Operate the Professional 3410 and 5410N System
Pause the System
You can pause the system to add discs to the carousel.
1. Open the front door. The operation pauses.
2. Close the front door. The operation resumes.
Load the Discs
You can load up to 50 discs in each input bin. Use the procedure below to
load discs in each bin.
Important! Place the discs with the recording side facing down.
Tip: Through the Rimage software, you may designate bins 1 through 3 as
input, output, reject/output, and specify a media type for each bin .
1. Open the front door.
2. Press the rotate carousel button to rotate the carousel to the desired
bin. You may have to press the button more than once to reach the
desired bin.
3. Add desired discs.
4. Repeat steps 2 - 3 until the required bins are filled.
5. Close the front door.
Unload the Discs
1. Open the front door.
2. Press the rotate carousel button to rotate the carousel and place a bin
in position to remove discs.
3. Remove the discs from the bin.
4. Repeat steps 2 - 3 until the required bins are empty.
5. Close the front door.
Place a Disc on the Printer Tray
Use this procedure to manually place a disc on the printer tray.
1.
2.
3.
For more information visit
rimage.com/support
Press the printer tray button on the control panel. The printer tray
opens.
Place the disc on the print pad with the printable surface facing up and
the stacking ring facing the print pad.
Important! To avoid scratching or damaging the recording surface of the
disc, the disc must not rest on the clamping pins or the centering pin.
Press the printer tray button. The printer tray closes.
Clamping Pins
14
Advertisement
Table of Contents
